Toe Adjustment - Rear
- Using alignment equipment and the manufacturer's instructions, measure the rear toe.
- Start the engine and center the steering wheel.
- Turn the engine OFF and using a suitable holding device, hold the steering wheel in the straight-ahead position.
- Loosen the toe link nut approximately one full turn.
- From the opposite side, rotate the toe link bolt to achieve the specified toe setting.
- While holding the toe link bolt, tighten the nut to 100 Nm (74 lb-ft).
- Recheck the toe settings and adjust as necessary.
NOTE:
Use a steering wheel holding device (such as Hunter® 28-75-1 or equivalent).
NOTE:
Make sure that the toe settings are not disturbed while tightening the nuts.