FixVault
Home › Mercury › 2009 › Sable Premier, AWD › Repair and Diagnosis › External Pages › Different car › Section 1216 (Electronic Engine Control System) › Removal And Installation › Mass Air Flow (MAF) Sensor › Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the mass air flow (MAF) sensor electrical connector.
  2. Remove the 2 screws and the MAF sensor.
    • To install, tighten to 2 Nm (18 lb-in).
  3. To install, reverse the removal procedure.
About FixVault