Refrigerator Module

WARNING: This page is about a different car, the 2011 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear floor console refrigerator. For additional information, refer to REFRIGERATOR .

NOTE: Do not bend the condenser tubes. The screw driver must fit between the condenser tubes or damage may occur to the refrigerator.

Fig 1: Locating Refrigerator Module Mounting Bracket Phillips Screw

Courtesy of FORD MOTOR CO.

Using a long thin screw driver, remove the Phillips screw from the refrigerator module mounting bracket.
Disconnect the upper electrical connector from the refrigerator module.

Fig 2: Disconnecting Upper Electrical Connector From Refrigerator Module
Courtesy of FORD MOTOR CO.
Rotate the refrigerator module to the right and remove from the mounting bracket.

Fig 3: Rotating Refrigerator Module To Right
Courtesy of FORD MOTOR CO.
Disconnect the lower electrical connector from the refrigerator module.

Fig 4: Disconnecting Lower Electrical Connector From Refrigerator Module
Courtesy of FORD MOTOR CO.
Disconnect the refrigerator module-to-refrigerator electrical connector.

Fig 5: Disconnecting Refrigerator Module-To-Refrigerator Electrical Connector
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.