33 17... Replacing rubber mount

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 4 281
33 4 282
33 4 283
33 4 284
33 4 465
33 4 466

Withdrawing rubber mount:

Withdraw rubber mount with special tools 33 4 282, 33 4 281, 33 4 466, 33 4 465 and a nut (1).

Fig 1: Nut, Special Tools (33 4 282), (33 4 281), (33 4 465), (33 4 466) And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Installing rubber mount:

IMPORTANT: Coat bearing bushing in rear axle carrier and new rubber mount with Circolight.

Align rubber mount by way of elongated hole (1) to vehicle transversal direction.

Fig 2: Elongated Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount (1) in special tool 33 4 283.

Align rubber mount (1) by way of elongated hole to vehicle transversal direction.

Draw in rubber mount (1) with special tools 33 4 282, 33 4 283, 33 4 284, 33 4 466, 33 4 465 and nut (2) as far as it will go.

Fig 3: Rubber Mount, Nut, Special Tools (33 4 282), (33 4 283), (33 4 284), (33 4 466), (33 4 465) And Installation Direction

Courtesy of BMW OF NORTH AMERICA, INC.