11 61 050 Removing and installing intake plenum (N16)

Necessary preliminary tasks:

Detach engine wiring harness (1) from intake manifold.

Disconnect plug connection (2).

Unplug connector (3) from tank vent valve.

Fig 1: Identifying Engine Wiring Harness, Plug Connection, And Tank Vent Valve Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release tank vent valve (2).

Fig 2: Identifying Plug Connection And Tank Vent Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) on solenoid valve.

Release engine breathers and hold to one side.

Slacken nut (2).

Tightening torque: 11 61 1AZ .

Fig 3: Identifying Plug Connection On Solenoid Valve And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Detach engine wiring harness (2) from intake manifold.

Fig 4: Identifying Plug Connection And Engine Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Detach cable (1) from intake manifold bracket.

Release screw (2).

Release screw (3).

Take off holder (4).

Tightening torque: 11 61 2AZ .

Fig 5: Identifying Holder, Screws, And Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release screw (2).

Unscrew nuts (3).

Tightening torque: 11 61 1AZ .

Fig 6: Identifying Plug Connection, Nuts, And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace all gaskets.

Assemble engine.