41 00... Bonding Steel On Steel

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2016 BMW 435i xDrive, 2016 BMW 435i, 2016 BMW 428i xDrive, 2016 BMW 428i, and 2015 BMW 435i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: These repair instructions apply to structural components.
Such components include engine supports, A-pillars, B-pillars, etc.
Follow the vehicle-specific repair instructions.
Only use the repair procedures described there.
Conform with safety regulations . See 4100... SAFETY AT WORK or 4100... INFORMATION ON HAZARDS !

Overview of topics:

Equipment
Preparing the surface
Bonding coat
Hardening times
Subsequent treatment

1.0 Equipment
- Sandpaper
- CLEANING AGENT R1
- ADHESIVE K1
- CARTRIDGE GUN
2.0 Preparing the surface:
- For better adhesion, remove oxide film and paint from the adhesive areas with a stainless steel wire brush or special sandpaper.
- Clean bonding surfaces with cleaning agent R1.
- Allow cleaned surfaces to dry for approx. 5 minutes.
  Bonding surfaces must be completely dry.
3.0 Adhesive application:
- Processing temperature of glue cartridge 18 °C - 30 °C.
- Object temperature, vehicle and new parts, min. 15°C.
- After applying the adhesive, check whether an adhesive component has emerged at the back of the glue cartridge. If yes, break off the bonding procedure. Clean new part. Use new glue cartridge. Contact national hotline.
- Join components and secure in position.
- Remove excess adhesive. Do not use solvent cleaning agents.
4.0 Hardening times:
- Refer to NOTES REGARDING ADHESIVE K1
5.0 Subsequent treatment of bonding surfaces:
- Protect the repair area with cavity sealant.