Bleeding Procedures

WARNING: This page is about a different car, the 2003 BMW Z8 and 2002 BMW Z8. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Use only clean brake fluid. Ensure no dirt or other foreign matter contaminates brake fluid. DO NOT mix different brands of brake fluid, as they may not be compatible. DO NOT spill brake fluid on car, as it will damage paint. If brake fluid contacts paint, immediately flush with water.

NOTE: With fixed caliper, bleed both sides of brake caliper, remove wheel if necessary.

Reservoir on master cylinder must be full at start of bleeding procedure. With aid of an assistant, slowly pump brake pedal several times, then apply steady pressure. Loosen brake bleed screw to allow air to escape from system.
Tighten bleed screw securely. Repeat procedure for each wheel in right rear, left rear, right front, and left front sequence. Road test vehicle and check brake performance.