51 11... Installing/Replacing License Plate (Without Base)

WARNING: This page is about a different car, the 2005 BMW 760Li, 2004 BMW 760i, 2004 BMW 760Li, and 2003 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Initial Fitting:

Place drilling hole template (1) on bumper (2).

Fig 1: Placing Drilling Hole Template On Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Installation:

Tightening torque, refer to 51 11 7AZ in BODY EQUIPMENT - TIGHTENING TORQUES .

Fit protective caps.

Repairing Thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1).

Secure license plate (3) with license plate screw (M5 x 20).

Installation:

Tightening torque, refer to 51 11 8AZ in BODY EQUIPMENT - TIGHTENING TORQUES .

Fig 2: Securing License Plate With License Plate Screw

Courtesy of BMW OF NORTH AMERICA, INC.