51 00... Notes on fitting window guide seals
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
1. Work safety when handling lubricant G13*
- Wear safety goggles, protective gloves and if necessary an apron.
- Do not eat, drink or smoke in the area of processing/application
- Ensure rooms are well ventilated.
- Keep heat and ignition sources well away
- In event of skin contact: Wash areas of skin affected with soap and water immediately, change work clothing which has been fouled with lubricant immediately (keep spare work clothing in reserve)
- In event of eye contact: Rinse eyes immediately with plenty of water and seek medical advice
- Observe safety data sheet (see BMW Aftersales Assistance Portal (ASAP) - Service/Technology - Safety Data Sheet - 7-digit part number)
2. General notes
- Use only the BMW-approved lubricant for fitting
- Application only at room and object temperatures between 18 and 25 °C
- Lubricant dries at different rates depending on the quantity, temperature and ventilation and becomes sticky
- Lubricant can only be used for fitting and not for fault elimination (e.g. grating)
- Newly painted parts may only be brought into contact with the lubricant after cooling
- Optimal bonding/attachment to the background surface is achieved after approx. 48 hours. The window guide seal must not be exposed to mechanical strain beforehand (car wash, strength test, etc.).
IMPORTANT:
To avoid grating noises, do not use soapy water (low-surface-tension water with washing-up liquid) or lubricant containing silicone
3. Auxiliary materials and tools
- CLEANING AGENT R1 OR CLEANING AGENT R2 , cleaning cloth, plastic scraper, needle
- Lubricant G13* (manufactured by Zestron) part no. 83 23 0441 032
(*sourcing reference: BMW Parts Service)
4. Preparations
- Heat and remove anti-friction agent residues with a hot air blower or clean new part thoroughly
- Immediately prior to fitting, clean the work area in order to remove silicone and grease residues
NOTE:
Air drying time approx. 1 minute
5. Installation
- Apply a thin coating of lubricant to the reverse side of the window guide seal only
- Perform fitting within 30 minutes of applying lubricant
- Lubricant dries after fitting and becomes sticky