FixVault
Home › Mini › 2012 › Cooper Base, 2D Hatchback, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 1264 (Maintenance And General Information - Repair Instructions) › Maintenance & General Info › 00... Notes On SMG Transmission Service Functions

00... Notes On SMG Transmission Service Functions

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The service functions must be carried out in the relevant order!
SMG TRANSMISSION SERVICE FUNCTIONS

When replacing SMG control unit
  1. Teach in clutch valve characteristic values
  2. Adapt complete transmission
  3. Teach in clutch slipping point
  4. Teach in offset of longitudinal-acceleration sensor
Before working on the hydraulic system, if the system:
  • is to be opened
  • is filled with hydraulic fluid (depressurization of hydraulic system)
  1. Reduce hydraulic pressure
After working on the hydraulic system, if the system was opened
  1. Bleed actuator block
  2. Bleed clutch slave cylinder and hydraulic lines
After removal and reinstallation of parts (no replacement of parts!)
  • Engine
  • Transmission
  • Clutch
  1. Teach in clutch valve characteristic values
  2. Adapt complete transmission
  3. Teach in clutch slipping point
When replacing transmission
When replacing hydraulic unit with actuator block
When replacing engine
NOTE: Perform points 1 and 2 only if the hydraulic system was opened.
  1. Bleed actuator block
  2. Bleed clutch slave cylinder and hydraulic lines
  3. Teach in clutch valve characteristic values
  4. Adapt complete transmission
  5. Teach in clutch slipping point
When replacing clutch
NOTE: Perform point 1 only if the hydraulic system was opened.
  1. Bleed clutch slave cylinder and hydraulic lines
  2. Teach in clutch valve characteristic values
  3. Teach in clutch slipping point
  4. Reset clutch curve (automatically carried out by BMW diagnosis system after successful teaching in of points 3 and 4)
When replacing individual clutch parts:
  • Release lever
  • Ball pin
  • Release bearing...
  1. Teach in clutch valve characteristic values
  2. Teach in clutch slipping point
  3. Reset clutch curve (automatically carried out by BMW diagnosis system after successful teaching in of points 1 and 2)
When replacing clutch slave cylinder with PLCD sensor
  1. Bleed actuator block
  2. Bleed clutch slave cylinder and hydraulic lines
  3. Teach in clutch valve characteristic values
  4. Teach in clutch slipping point
  5. Reset clutch curve (automatically carried out by BMW diagnosis system after successful teaching in of points 3 and 4)
When replacing longitudinal-acceleration sensor
  1. Teach in offset of longitudinal-acceleration sensor
About FixVault