51 00... Service Position Of Engine Hood/Bonnet
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools Required
- 51 0 040
- 51 2 160
- 51 2 170 HOOD/BONNET STAY (2X)
- 51 2 180
- 51 2 240
NOTE:
Only the special tool pertaining to the model series can be selected.
SPECIAL TOOLS REFERENCE TABLE
| Model Series | Special Tool |
|---|---|
| E46, R50, R52, R53 | 51 2 160 |
| E53, E60, E61, E63, E64, E71, E81, E82, E88, E85, E86, E87, E90, E91, E92, E93 | 51 2 170 |
| E65, E66, E67 | 51 2 180 |
| E83 | 51 0 040 |
| E70 | 51 2 240 |
WARNING:
Risk of injury and damage!
Engine hood/bonnet must be held by a second person helping.
NOTE:
The illustrations below serve as examples for all corresponding vehicles.
The operation is described on the left side; proceed in the same way for the right side.
Special tool can only be used on housing (1) of gas spring strut (thick part).
NOTE:
Gas spring strut can also be installed the other way round (housing on hood/bonnet).
Special tool can be used in both directions.
Release gas spring strut on left/right housing side.
Slide special tool (1) over housing (2) of gas spring strut.
Clip ball socket of special tool on ball stud.
Proceed in same way on other side.