51 11 ... Installing/Replacing License Plate (Without Base)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2003 BMW M3, and 2002 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Initial Fitting:

Place drilling hole template (1) on bumper (2).

Fig 1: Placing Drilling Hole Template On Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Installation:

Tightening torque, refer to 51 11 7AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 3-SERIES .

Fit protective caps.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1).

Secure license plate (3) with license plate screw (M5 x 20).

Installation:

Tightening torque 51 11 8AZ. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .

Fig 2: Securing License Plate With License Plate Screw

Courtesy of BMW OF NORTH AMERICA, INC.