86 10... Removing loading ramp lock: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Tightening Torque, 86 10 28AZ.

Fig 1: Identifying Loading Ramp Lock Bolt

G04766372

Courtesy of BMW OF NORTH AMERICA, INC.

Pass lever (1) of rotary striker lock (2) out of square hole (3) by twisting from side to side.

Fig 2: Identifying Rotary Striker Lock Lever With Square Hole

G04766373

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolts (1).

Opening for securing clip (2) points to front or rear.

Square-head nut (3) rests with its square surface parallel to bearing pedestal (4).

Tightening Torque, 86 10 29AZ.

Fig 1: Identifying Clip, Square-Head Nut With Bearing Pedestal And Loading Ramp Bolt

G04766374

Courtesy of BMW OF NORTH AMERICA, INC.

Raise edge (1) of securing clip and slide in direction of arrow towards rear.

Detach bearing pedestal (2).

Fig 2: Removing Bearing Pedestal

G04766375

Courtesy of BMW OF NORTH AMERICA, INC.

Install bearing pedestal (1) on stub (3) of locking bracket (3).

Off-center bore (4) in bearing pedestal (1) points with short distance (A) to locking bracket (3).

Fig 1: Identifying Bearing Pedestal On Stub Of Locking Bracket

G04766376

Courtesy of BMW OF NORTH AMERICA, INC.