Encode/program control unit(s) (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Depending on the vehicle and the equipment, the following flat rate unit positions are available for programming/encoding:

61 00 710
61 00 720
61 00 730

NOTE:

In order to avoid incorrect programming procedures and Check Control message, it is essential to always use the most recent version when working with the ISTA/P programming system.
Battery voltage must not undershoot 13.0 V during programming. Connect battery charger prior to programming.

Only use battery chargers*

recommended by BMW for low voltage vehicle electrical system.

*Sourcing reference- applicable BMW Workshop Equipment Catalog

IMPORTANT: No high-voltage switch off is required in electric vehicles or hybrid vehicles for programming/coding.

The high-voltage system will be automatically switched off by the programming system.

Exception:

BMW I01: Observe Service Information

See the applicable BMW Bulletin

programming routine via ISTA/P:

Connect the battery charger to the vehicle.
Connect the programming system with the vehicle.
Determine the action plan.
Accept and carry out programming/encoding action plan, if necessary unlocking control unit.
Observe the reworking list!
If applicable, connect the workshop system to the vehicle, depending on the reworking list. Perform brief test and delete fault memory.

NOTE: A switch to the workshop system may not necessarily be required with the integration of the service functions and the "Fault memory deletion" function in ISTA/P. Check the rework list accordingly!

The information about programming the workshop system and the corresponding notes in the user documentation must be observed.