Modifying ECI Checker / Labels For FBC Harness (STB-84-14-007)

MODIFYING ECI CHECKER / LABELS FOR FBC HARNESS

TECHNICAL SERVICE BULLETIN

ECI CHECKER AND FBC HARNESS CONNECTOR MODIFICATION

Models 1984 Cordia, Tredia, Starion, California Montero

Bulletin No. STB-84-14-007

Date April, 1984

SERVICE INFORMATION

This bulletin contains information on

I) modification to the ECI Checker harness

II) labels to be added to the FBC Harness Connector.

Both are necessary to prevent damage to the ECI Checker and vehicle wiring harness that can result from improperly connecting the ECI Checker harness and the FBC Harness Connector (Special Tool No. MD998408) to the vehicle wiring harness.

Quantity	Description
1	1O-Amp fuse (automotive type)
1	2 1/4" female blade-type wire terminals
1	wire tie
6	labels (furnished with this bulletin) Check with Mitsubishi parts supplier.

I. MODIFICATION PROCEDURE - ECI CHECKER

1. Place the ECI Checker on a bench. Identity the connector with 13 male pins in a female body.
2. Slide back the protective loom on the harness to reveal a jumper wire connecting pins #2 and #10.
   NOTE: Pins #2 and #10 can be identified by numbers molded into the plastic body of the connector, and the two cavities are the only ones with two wires leading into them.
3. Cut the jumper wire in the middle, strip the insulation from the cut ends, and crimp on the two female blade-type terminals.
4. Install the 1O-Amp fuse on the two terminals.
5. Pull the protective loom back into place, leaving the fuse showing. Fasten the loom securely with a wire tie.

II. ADDITION OF LABELS TO THE FBC HARNESS CONNECTOR

1. Obtain labels stick them onto the connectors of the FBC Harness Connector.