Combination Switch

Remove combination switch from steering column. Using an ohmmeter check for continuity between terminals of each connector in each switch position. Ensure that wire leads are not being pulled while moving switch from one position to another.
Ensure switch lever works freely without binding. Check continuity according to the following charts. See Fig 1 , Fig 2 , & Fig 3 .

Fig 1: Lighting Switch Testing

Courtesy of HYUNDAI MOTOR CO.

Fig 2: Dimmer/Passing Switch Testing

Courtesy of HYUNDAI MOTOR CO.

Fig 3: Turn Signal/Hazard Switch Testing

Courtesy of HYUNDAI MOTOR CO.

LIGHTING SWITCH CONTINUITY TEST

DIMMER & PASSING SWITCH CONTINUITY TEST

HAZARD & TURN SIGNAL SWITCH CONTINUITY TEST

FRONT WIPER SWITCH CONTINUITY TEST

FRONT WASHER SWITCH CONTINUITY TEST

Switch Position	Wire Colors	Continuity
Off	Any	No
On	BLK/WHT & BLK	Yes