Other Monitor
This monitor applies to DTCs not covered by other monitors. Following conditions must be met during the test:
- Engine coolant temperature must be 176°F (80°C) or greater.
- Atmospheric temperature is 41°F (5°C) or greater.
- Selector lever is in "D" range.
Monitor takes about 10 minutes to complete. This cycle must be completed 2 times. Run monitor as shown. See Fig 1 . Remove all test equipment from vehicle and install all components and connectors that were removed or disconnected during testing. Perform steps as follows:
- Start engine and accelerate to 35-40 MPH.
- Drive for 5 minutes or more at 35-40 MPH.
- Return vehicle to shop and let idle. While engine is idling, A/C switch must be in OFF position, lights and accessories must be off, steering wheel must be straight ahead, and transaxle must be in neutral. After idling for 5 minutes, Turn the ignition switch to LOCK position.
- Recheck for DTCs. If any DTC other than P0130, P0133, P0136, P0139, P0171, P0172, P0401, P0442, P0450, P0451, P0455 or P0421 resets, return to appropriate repair procedure under DIAGNOSTIC TESTS .