FixVault
Home › Mitsubishi › 2003 › Lancer Evolution › Repair and Diagnosis › External Pages › Different car › Section 54 (Engine Controls - Self-Diagnostics) › Diagnostic Tests › DTC P0441: EVAP Control System › DTC Confirmation Test (Using CONSULT-II)

DTC Confirmation Test (Using CONSULT-II)

WARNING: This page is about a different car, the 2002 Nissan Xterra and 2002 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine and warm to normal operating temperature.
  2. Turn ignition off and wait at least 5 seconds.
  3. Start engine and let it idle for at least 70 seconds.
  4. Select PURG FLOW P0441 of EVAPORATIVE SYSTEM in DTC CONFIRMATION mode with CONSULT-II.
  5. Press START. If COMPLETED is displayed, go to step  7 . If COMPLETED is not displayed, go to next step.
  6. When the following conditions are met, TESTING will be displayed on CONSULT-II screen:

    2.4L Models

    • Vehicle speed: 20-75 MPH.
    • ENG SPEED: 500-3750 RPM.
    • Engine coolant temperature: more than 158°F (70°C).

    3.3L Models

    • Vehicle speed: 20-75 MPH.
    • ENG SPEED: 500-3400 RPM.
    • B/FUEL SCHDL: 1.0-10.0 msec.
    • Engine coolant temperature: 158-212°F (70-100°C).

    On all models, maintain conditions continuously until TESTING changes to COMPLETED (it will take at least 35 seconds).

    NOTE: If TESTING does not change to COMPLETED, retry from step  2 .
  7. Press SELF-DIAG RESULTS. If NG is displayed, go to DIAGNOSTIC PROCEDURE  . If OK is displayed, system is okay at this time.
About FixVault