FixVault
Home › Mitsubishi › 2004 › Lancer Evolution › Repair and Diagnosis › External Pages › Different car › Section 11 (Air Bag Restraint Systems) › Component Testing › Occupant Classification Sensor Calibration

Occupant Classification Sensor Calibration

WARNING: This page is about a different car, the 2004 Mitsubishi Galant. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect scan tool to Data Link Connector (DLC). See INITIAL SRS DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Go to next step.
  2. Open and close passenger-side front door 5 times hard to remove friction. If door does not open and close smoothly after the impact, hit front and rear sides of seat back about 8 times each to remove friction. Go to next step.
  3. Select INTERACTIVE DIAGNOSIS, then SPECIAL FUNCTION then SEAT WEIGHT SENSOR ACCURACY CHECK on screen. Slide passenger-side front seat to full forward position. Place a 66 pound weight (30 kg) in center of passenger-side seat cushion. Repeat step 2 . Touch OK button to perform accuracy check.
  4. If variance between sensor output and input levels is within 11 pounds (5 kg), ACCURACY CHECK COMPLETION will be displayed on screen. Go to step  6 . If ACCURACY CHECK COMPLETION is not displayed, go to next step.
  5. If ABNORMAL CONDITION is displayed, press OK and go to calibration screen. Remove weight from seat. Verify seat is installed correctly. If seat is installed correctly, go to step  1 .
  6. Remove weight from seat cushion. Move seat to rear most position. Repeat step 2 . Go to next step.
  7. Select INTERACTIVE DIAGNOSIS, then SPECIAL FUNCTION then SEAT WEIGHT SENSOR ACCURACY CHECK on screen. Place a 66 pound weight (30 kg) in center of passenger-side seat cushion. Repeat step 2 . Touch OK button to perform accuracy check. Go to next step.
  8. If variance between sensor output and input levels is within 11 pounds (5 kg), ACCURACY CHECK COMPLETION will be displayed on screen. Calibration is complete. If ACCURACY CHECK COMPLETION is not displayed, go to next step.
  9. Verify seat is installed correctly. Repeat step 2 . Touch OK button. When EXECUTION prompt is displayed, touch OK button. When calibration is completed, screen will display ZERO CALIBRATION COMPLETED. If calibration cannot be completed, an intermittent condition may exist.
About FixVault