G-Sensor Check

Required Special Tool: 

• MB991348: Test Harness Set

1. Disconnect the G-sensor connector and connect special tool MB991348, between terminals of the disconnected connector.
2. With the ignition switch turned to the "ON" position, read the voltage between terminals number 2 and number 3.

   Standard Value: 2.4 - 2.6 V 

3. With special tool MB991348 connected, rotate so that the arrow faces straight down. Read output voltage between terminals number 2 and number 3.

   Standard Value: 3.4 - 3.6 V 

   Fig 1: Checking G-Sensor

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
4. If the voltage deviates from the standard value, make sure that nothing is wrong with the power supply wire and ground wire and then replace the G-sensor.