Auto-cruise Control Check
Measure the resistance between the terminals when each of the "SET," "RESUME," "CANCEL" and "MAIN" switches is pressed. If the values measured at the time correspond to those in the table below, the resistance values are correct.
TERMINALS CONNECTOR SPECIFICATION
| SWITCH POSITION | TERMINAL CONNECTOR OF TESTER | SPECIFIED CONDITION |
|---|---|---|
| "MAIN" switch "OFF" | 1 - 2 | Open circuit |
| "MAIN" switch "ON" | 1 - 2 | Approximately 3.9 kΩ |
| "CANCEL" switch "ON" | 2 - 3 | Less than 2 ohms |
| "RESUME" switch "ON" | 2 - 3 | Approximately 910 Ω |
| "SET" switch "ON" | 2 - 3 | Approximately 220 Ω |