Section 3 (General -- Except Evolution)
WARNING: This page is about a different variant/trim than selected.
- General
- How To Use This Manual
- Troubleshooting Guidelines
- How To Use Troubleshooting/Inspection Service Points
- Troubleshooting Contents
- Standard Flow Of Diagnostic Troubleshooting
- System Operation And Symptom Verification Tests
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Symptom Chart
- Diagnostic Trouble Code Procedures
- Symptom Procedures
- Service Data Reference Table
- Check At Ecu Terminals
- Terminal Voltage Checks
- Terminal Resistance And Continuity Checks
- Inspection Procedures Using An Oscilloscope
- How To Use The Inspection Procedures
- Harness Inspection
- Measures To Take After Replacing The Ecu
- Connector Measurement Service Points
- If Inspecting With The Connector Connected < Waterproof Connectors >
- If Inspecting With The Connector Connected < Ordinary (Non-Waterproof) Connectors >
- If Inspecting With The Connector Disconnected < When Inspecting A Female Pin >
- If Inspecting With The Connector Disconnected < When Inspecting A Male Pin >
- Connector Inspection Service Points
- Connector Pin Inspection
- Connector Engagement Inspection
- How To Cope With Intermittent Malfunctions
- To Cope With Intermittent Malfunction
- Simulation Tests
- Inspection Service Points For A Blown Fuse
- Vehicle Identification
- Precautions Before Service
- Supplemental Restraint System (SRS)
- How To Perform Vehicle Identification Number (VIN) Writing
- Initialization Procedure For Learning Value In MFI Engine
- Learning Procedure For Idling In MFI Engine
- Servicing Electrical System
- Vehicle Washing
- Application Of Anti-Corrosion Agents And Undercoats
- Scan Tool (Mut-III Sub Assembly)
- Towing And Hoisting
- General Data And Specifications
- Tightening Torque
- Lubrication And Maintenance
- Recommended Lubricants And Lubricant Capacities Table
- Scheduled Maintenance Table
- Maintenance Service
- 1. Fuel System (Tank, Pipe Line And Connection, And Fuel Tank Filler Tube Cap) (Check For Leaks)
- 2. Fuel Hoses (Check Condition)
- 3. Air Cleaner Element (Replace)
- 4. Evaporative Emission Control System (Except Evaporative Emission Canister) (Check For Clogging)
- 5. Spark Plugs (Replace)
- 6. Intake And Exhaust Valve Clearance (Inspect And Adjust)
- 7. Timing Belt (Replace)
- 8. Drive Belt (For Generator, Power Steering Oil Pump And A/C Compressor) (Check Condition)
- 9. Exhaust System (Connections, Pipes And Converter Heat Shields) (Check And Service As Required)
- 10. Engine Oil (Change)
- 11. Engine Oil Filter (Replace)
- 12. Manual Transaxle Oil
- 13. Automatic Transaxle Fluid
- 14. Engine Coolant (Change)
- 15. Disc Brake Pads (Inspect For Wear)
- 16. Rear Drum Brake Linings And Rear Wheel Cylinders (Inspect For Wear And Leaks)
- 17. Brake Hoses (Check For Deterioration Or Leaks)
- 18. Ball Joint And Steering Linkage Seals (Inspect For Grease Leaks And Damage)
- 19. Drive Shaft Boots (Inspect For Grease Leaks And Damage)
- 20. SRS Air Bag (Inspect For SRS System)
- Notes
- SRS Warning Light Check
- SRS Component Visual Check
- Side Impact Sensors
- Replace The Side Impact Sensor If It Fails The Visual Check
- SRS Air Bag Control Unit (SRS-Ecu)
- Air Bag Module, Steering Wheel And Clock Spring
- Front Seatback Assembly With Side-Airbag Module
- Seat Belt With Pre-TENSIONER
- Wiring Harness
- 21. Tires (Rotate)
- Main Sealant And Adhesive Table