Rear Suspension & Wheel Alignment - Evolution

• General Description
  • Notes
  • Structure
  • Component Characteristics (Compared To The Lancer)
    • Suspension Arm (Made Of Forged Aluminum)
    • CROSSMEMBER (Made Of Forged Aluminum)
    • Shock Absorber, Coil Spring, Stabilizer, Bump Rubber
  • Construction Diagram
• Rear Suspension Diagnosis
  • Introduction To Rear Suspension Diagnosis
  • Rear Suspension Diagnostic Troubleshooting Strategy
  • Symptom Chart
  • Symptom Procedures
    • INSPECTION PROCEDURE 1: Squeaks or other Abnormal Noise
      • Diagnosis
    • INSPECTION PROCEDURE 2: Poor Ride
      • Diagnosis
    • INSPECTION PROCEDURE 3: Body Tilting
      • Diagnosis
• Special Tools
• On-Vehicle Service
  • Rear Wheel Alignment Check And Adjustment
    • Notes
    • Toe-In
    • Camber
  • Ball Joint Dust Cover Inspection
• Rear Suspension Assembly
  • Removal And Installation
    • Notes
    • Removal Service Points
      • << A >> Brake Caliper Assembly Removal
      • << B >> Propeller Shaft Disconnection
      • << C >> CROSSMEMBER Mounting Bolt Removal
    • Installation Service Points
      • >> A << CROSSMEMBER Mounting Bolt Installation
      • >> B << Propeller Shaft Connection
• Upper Arm Assembly
  • Removal And Installation
    • Notes
    • Removal Service Points
      • << A >> Upper Arm Ball Joint And Knuckle Disconnection
  • Inspection
    • Upper Arm Ball Joint Turning Torque Check
  • Upper Arm Ball Joint Dust Cover Check
    • Notes
    • Upper Arm Ball Joint Dust Cover Replacement
• Trailing Arm
  • Removal And Installation
    • Notes
    • Removal Service Point
      • << A >> Trailing Arm Assembly And Knuckle Disconnection
  • Inspection
    • Trailing Arm Ball Joint Turning Torque Check
    • Trailing Arm Ball Joint Dust Cover Check
  • Trailing Arm Ball Joint Dust Cover Replacement
• Lower Arm Assembly And Assist Link
  • Removal And Installation
    • Notes
    • Removal Service Points
      • << A >> Lower Arm Assembly Mounting Bolt Removal
      • << B >> Assist Link And Knuckle Disconnection
      • << C >> Assist Link Mounting Bolt Removal
    • Installation Service Point
      • >> A << Lower Arm Assembly Installation
  • Inspection
    • Assist Link Ball Joint Turning Torque Check
    • Assist Link Slide Bushing Turning Torque Check
    • Assist Link Ball Joint Dust Cover Check
    • Lower Arm Pillow Ball Bushing Turning Torque Check
  • Assist Link Ball Joint Dust Cover Replacement
• Shock Absorber Assembly
  • Removal And Installation
  • Disassembly And Assembly
    • Notes
    • Disassembly Service Point
      • << A >> Coil Spring Nut Removal
    • Assembly Service Points
      • >> A << Coil Spring Installation
      • >> B << Spring Upper Pad Installation
      • >> C << Shock Absorber Insulator Installation
      • >> D << Coil Spring Nut Installation
• Stabilizer Bar
  • Removal And Installation
    • Notes
    • Installation Service Point
      • >> A << Stabilizer Bar/Stabilizer Bushing/Stabilizer Bar Bracket Installation
  • Inspection
    • Stabilizer Bar Link Ball Joint Turning Torque Check
    • Stabilizer Bar Link Ball Joint Dust Cover Check
  • Stabilizer Bar Link Ball Joint Dust Cover Replacement
• Specifications
  • Fastener Tightening Specifications
  • General Specifications
    • Coil Spring
  • Service Specifications