Data List Reference Table

WARNING: This page is about a different car, the 2006 Mitsubishi Montero. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

When shifting the selector lever to D range, the brakes should be applied so that the vehicle does not move forward.
Driving tests always need two persons: one driver and one observer.

DATA LIST REFERENCE

MUT-III SCAN TOOL DISPLAY	ITEM NO.	INSPECTION ITEM		INSPECTION REQUIREMENT		NORMAL CONDITION
APS SNS (MAIN)	12	Accelerator pedal position sensor (main)		Ignition switch: "ON"	Accelerator pedal: Released	905 - 1,165 mV
					Accelerator pedal: Gradually depressed	Increases in response to the pedal depression stroke
					Accelerator pedal: Fully depressed	4,035 mV or more
BRAKE SW	06	Stoplight switch		Brake pedal: Depressed		ON
BRAKE SW	06	Stoplight switch		Brake pedal: Released		OFF
CANCEL CODE	13	Cancel code		Ignition switch: "ON"		The cancel code, which set when the auto-cruise control system was cancelled at the last time, is set again.
CANCEL SWITCH	04	Auto-cruise control switch	CANCEL	"CANCEL" switch: ON		ON
CANCEL SWITCH	04	Auto-cruise control switch	CANCEL	"CANCEL" switch: OFF		OFF
CRUISE	09	Auto-cruise control operation		Auto-cruise control: Active		ON
CRUISE	09	Auto-cruise control operation		Auto-cruise control: Inactive		OFF
IDLE SW SIG	08	Accelerator pedal position switch		Accelerator pedal: Depressed		OFF
IDLE SW SIG	08	Accelerator pedal position switch		Accelerator pedal: Released		ON
MAIN SW	01	Auto-cruise control switch	MAIN	MAIN switch: "ON"		ON
MAIN SW	01	Auto-cruise control switch	MAIN	MAIN switch: "OFF"		OFF
RESUME SWITCH	03	Auto-cruise control switch	RESUME	"RESUME" switch: ON		ON
RESUME SWITCH	03	Auto-cruise control switch	RESUME	"RESUME" switch: OFF		OFF
SET SWITCH	02	Auto-cruise control switch	SET	"SET" switch: ON		ON
SET SWITCH	02	Auto-cruise control switch	SET	"SET" switch: OFF		OFF
STOPLIGHT SW	05	Stoplight switch		Brake pedal: Depressed		ON
STOPLIGHT SW	05	Stoplight switch		Brake pedal: Released		OFF
TP SNSR (MAIN)	11	Throttle position sensor (main)*		Remove the intake air hose at the throttle body Disconnect the throttle position sensor connector, and then connect terminal numbers No. 1, No. 2, No. 3 and No. 4 with the use of the special tool: MB991658. Ignition switch: ON	Fully close the throttle valve with your finger	200 - 800 mV
					Fully open the throttle valve with your finger	3,800 - 4,900 mV
				No load		450 - 1,000 mV
				A/C switch: "OFF" to "ON"		Voltage rises
				A/C switch: "OFF" Selector lever: "N" to "D"		Voltage rises
CLUTCH SW	07	Transmission range switch		Selector lever: "P" or "N" position		ON
CLUTCH SW	07	Transmission range switch		Selector lever: "R" or "D" position		OFF
VSS	10	Vehicle speed sensor		Road test the vehicle		The speedometer and scan tool MB991958 display the same value.
NOTE: *: Disconnect the throttle position sensor connector, and then delete the diagnostic trouble code that was recorded during the inspection with the use of the MB991502 scan tool after the inspection has been completed.