Fastener Tightening Specifications
TIGHTENING SPECIFICATIONS
| ITEM | SPECIFICATION |
|---|---|
| Front bearing retainer mounting bolt | 18 +/- 3 N.m (13 +/- 2 ft-lb) |
| Clutch housing-transaxle case mounting bolt | 44 +/- 5 N.m (32 +/- 4 ft-lb) |
| Reverse idler gear shaft mounting bolt | 48 +/- 6 N.m (35 +/- 4 ft-lb) |
| Under cover mounting bolt | 6.9 +/- 0.9 N.m (61 +/- 8 in-lb) |
| Control housing mounting bolt | 18 +/- 3 N.m (13 +/- 2 ft-lb) |
| Interlock plate bolt | 30 +/- 3 N.m (22 +/- 2 ft-lb) |
| Harness bracket bolt | 18 +/- 3 N.m (13 +/- 2 ft-lb) |
| Poppet spring | 32 +/- 2 N.m (24 +/- 1 ft-lb) |
| Backup light switch | 32 +/- 2 N.m (24 +/- 1 ft-lb) |
| Speedometer gear mounting bolt | 3.9 +/- 1.0 N.m (35 +/- 9 in-lb) |
| Select lever mounting bolt | 18 +/- 3 N.m (13 +/- 2 ft-lb) |
| Shift cable bracket mounting bolt | 18 +/- 3 N.m (13 +/- 2 ft-lb) |
| Roll stopper bracket mounting bolt | 70 +/- 10 N.m (52 +/- 7 ft-lb) |
| Transfer - clutch housing mounting bolt < W5M42 > | 69 +/- 10 N.m (51 +/- 7 ft-lb) |
| Select lever mounting nut | 11 +/- 1 N.m (97 +/- 8 in-lb) |
| Stopper bracket mounting bolt | 21.7 +/- 0.3 N.m (16.0 +/- 0.2 ft-lb) |
| Clutch release bearing retainer mounting bolt | 9.8 +/- 2.0 N.m (87 +/- 17 in-lb) |
| Differential drive gear mounting bolt < F5M42 > | 132 +/- 5 N.m (97 +/- 4 ft-lb) |
| Center differential drive gear mounting bolt < W5M42 > | 132 +/- 5 N.m (97 +/- 4 ft-lb) |
| Transfer cover mounting bolt < W5M42 > | 23 +/- 3 N.m (17 +/- 2 ft-lb) |