FixVault
Home › Mitsubishi › 2006 › Montero › Repair and Diagnosis › Brakes › Traction Control › Anti-Lock Braking System (Abs) › Abs Diagnosis › Data List Reference Table

Data List Reference Table

The following items can be read by the scan tool from the M-ASTC-ECU input data.

DATA LIST REFERENCE TABLE

MUT-III SCAN TOOL DISPLAY* ITEM NO. CHECK ITEM CHECKING REQUIREMENTS NORMAL VALUE
ACCUM SW(PH) 77 Accumulator switch (PH) Accumulator fluid pressure reduces to less than approx. 16.1 MPa ON
Accumulator fluid pressure reaches approx. 18.3 MPa OFF
ACCUM SW(PL) 76 Accumulator switch (PL) Accumulator fluid pressure reduces to approx. 10.8 MPa or less. ON
APS 16 Accelerator pedal position sensor Ignition switch: ON Release the accelerator pedal 905 - 1,165 mV
Depress the accelerator pedal gradually Increases in response to the pedal depression stroke
Depress the accelerator pedal fully 4,035 mV or more
C/D LOCK SW 83 Center differential lock detection switch Ignition switch: ON
Transmission range: N		 Transfer shift lever position: 4HLc or 4LLc ON
Transfer shift lever position: 2H or 4H OFF
M-ASTC OFF SW 37 Active skid control switch Set the active skid control switch to the neutral position OFF
Turn the active skid control switch to the OFF position ON
M-ASTC ON SW 38 Active skid control switch Set the active skid control switch to the neutral position OFF
Turn the active skid control switch to the ON position ON
BATT. VOLTAGE 31 M-ASTC-ECU power supply voltage Ignition switch power supply voltage and valve monitor voltage 6.5 - 22.3 V
ENGINE SPEED 17 Engine speed Drive the vehicle The scan tool and the tachometer readings are approximately the same
EN. TYPE/DESTN 28 Engine model and destination - 6G75 NAS
FR SNSR 11 Front right ABS sensor Drive the vehicle Vehicle speeds displayed on the speedometer and scan tool are identical.
FL SNSR 12 Front left ABS sensor
G SENS VOLT 1 22 Output 1 from G sensor Drive the vehicle -14.7 - 14.7 m/s2
G SENS VOLT 2 23 Output 2 from G sensor
G SENSOR VOLT 19 Output from G sensor (longitudinal acceleration)
G S(LATERAL) 20 Output from G sensor (lateral acceleration)
IDLE POS. SW 75 Closed throttle position switch Do not depress the accelerator pedal ON
Depress the accelerator pedal OFF
TR SWITCH 26 Transmission range switch Drive the vehicle The shift lever position indicator and the scan tool readings are equal
M/C PRESS. SNSR 24 Master cylinder pressure sensor When depressing gradually the brake pedal, the output value will change. Approximately 0.5 - 4.5 V
MOTOR RLY 79 Motor relay Motor relay is operating ON
Motor relay is not operating OFF
RR SNSR 13 Rear right ABS sensor Drive the vehicle Vehicle speeds displayed on the speedometer and scan tool are identical.
RL SNSR 14 Rear left ABS sensor
SHIFT POSIT. 27 Shift position Drive the vehicle The shift lever position indicator and the scan tool readings are equal
ST ANGLE 32 Steering wheel angle Steering wheel angle deg (approximately the same as actual steering wheel angle)
STOPLIGHT SW 36 Stoplight switch Depress the brake pedal. ON
Release the brake pedal. OFF
T/F MODE 30 Transfer position Drive the vehicle. the same as actual transfer position
T/F 2H SW 80 2H detection switch Ignition switch: ON
Transmission range: N		 Transfer shift lever position: 2H ON
Transfer shift lever position: Other than 2H OFF
T/F 2/4H SW 81 2WD/4WD detection switch Ignition switch: ON
Transmission range: N		 Transfer shift lever position: 2H or 4H ON
Transfer shift lever position: 4HLc or 4LLc OFF
T/F 4H SW 82 4H detection switch Ignition switch: ON
Transmission range: N		 Transfer shift lever position: 4H or 4HLc ON
Transfer shift lever position: 2H or 4LLc OFF
T/F 4L SW 84 4LLc detection switch Ignition switch: ON
Transmission range: N		 Transfer shift lever position: 4LLc ON
Transfer shift lever position: Other than 4LLc OFF
VALVE RLY 78 Valve relay Valve relay is operating ON
Valve relay is not operating OFF
YAW RATE SNSR 21 Yaw rate sensor Ignition switch: ON - -95 - 95 deg/s
About FixVault