Auto-Cruise Control Switch Check

1. REMOVE THE AUTO-CRUISE CONTROL SWITCH . ).
2. Measure the resistance between terminal 2 and terminal 3 when each of the "COAST/SET", "ACC/RES", "CANCEL" and "CRUISE" (MAIN) switches is pressed. If the values measured at the time correspond to those in the table below, the resistance values are correct.

SWITCH POSITION

SWITCH POSITION	SPECIFIED CONDITION
"CRUISE" (MAIN) switch "OFF"	Open circuit
"CRUISE" (MAIN) switch "ON"	Less than 2 ohms
"CANCEL" switch ON	Approximately 100 Ω
"ACC/RES" switch ON	Approximately 887 Ω
"COAST/SET" switch ON	Approximately 300 Ω

Fig 1: Identifying Auto-Cruise Control Switch Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.