FixVault
Home › Mitsubishi › 2006 › Outlander LS, AWD, Standard › Repair and Diagnosis › Restraints › Restraints Control Systems › Supplemental Restraint System › Inspection › Installation Service Points › >>A<< Pre-Installation Inspection

>>A<< Pre-Installation Inspection

WARNING: Dispose of air bag modules only according to the specified procedure (Refer to AIR BAG MODULE AND SEAT BELT PRE-TENSIONER DISPOSAL PROCEDURES ).
  1. When installing the new air bag modules and clock spring, refer to "INSPECTION" ( AIR BAG MODULE CHECK ).
  2. Connect the negative (-) battery cable.
    CAUTION: To prevent damage to scan tool MB991958, always turn the ignition, switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
  3. Connect scan tool MB991958 to the data link connector.
  4. Turn the ignition switch to the "ON" position.
  5. Check DTCs using scan tool MB991958 to ensure entire SRS operates properly.

    At this time, check that no DTC except B1400, B1410, B1480 and B1490 are set.

    WARNING: Wait at least 60 seconds after disconnecting the battery cable before doing any further work (Refer to SERVICE PRECAUTIONS  ).
    WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
  6. Turn the ignition switch to the "LOCK" (OFF) position. Disconnect the negative (-) battery cable and tape the terminal to prevent accidental connection and air bags deployment.
About FixVault