FixVault
Home › Mitsubishi › 2007 › Eclipse GT, Standard › Repair and Diagnosis › Accessories & Equipment › Cruise Control Systems › Auto-Cruise Control › Auto-Cruise Control › Symptom Procedures › Data List Reference Table

Data List Reference Table

CAUTION:
  • Driving tests always need two persons: one driver and one observer.
  • When shifting the selector lever to "D" range apply the brakes should be applied so that the vehicle does not move forward < A/T >.
DATA LIST REFERENCE

MUT-III SCAN TOOL DISPLAY ITEM NO. INSPECTION ITEM INSPECTION REQUIREMENT NORMAL CONDITION
APS (main) 11 Accelerator pedal position sensor (main) Ignition switch: "ON" Accelerator pedal: Released 735 - 1,335 mV
Accelerator pedal: Gradually depressed Increases in response to the pedal depression stroke
Accelerator pedal: Fully depressed 4,000 mV or more
Brake light switch 74 Stoplight switch Brake pedal: Depressed ON
Brake pedal: Released OFF
Cancel code 57 Cancel code Ignition switch: "ON" The cancel code, which set when the auto-cruise control system was cancelled at the last time.
Cancel switch 75 Auto-cruise control switch CANCEL "CANCEL" switch: ON ON
"CANCEL" switch: OFF OFF
Clutch switch 78 Clutch pedal position switch < M/T > Clutch pedal: Depressed ON
Clutch pedal: Released OFF
Cruise switch 81 Auto-cruise control system operation Auto-cruise control system: active ON
Auto-cruise control system: Inactive OFF
Main switch 86 Auto-cruise control switch CRUISE (MAIN) "CRUISE" (MAIN) switch: "ON" ON
"CRUISE" (MAIN) switch: "OFF" OFF
Neutral switch 88 Transmission range switch < A/T > Transmission range switch: "N" position ON
Transmission range switch: Other than above OFF
Normally closed brake switch 89 Stoplight switch (brake switch) Brake pedal: Depressed ON
Brake pedal: Released OFF
Resume switch 91 Auto-cruise control switch ACC/RES "ACC/RES" switch: ON ON
"ACC/RES" switch: OFF OFF
Set switch 92 Auto-cruise control switch COAST/SET "COAST/SET" switch: ON ON
"COAST/SET" switch: OFF OFF
TPS (main) 13 Throttle position sensor (main) * (1)
  • Remove the intake air hose at the throttle body.
  • Disconnect the throttle position sensor connector, and then connect terminals 3, 4, 5 and 6 with the use of the special tool: MB991658 (Test harness).
  • Ignition switch: "ON"
 Fully close the throttle valve with your finger 300 - 700 mV
Fully open the throttle valve with your finger 4,000 mV or more
No load 520 - 620 mV
A/C switch: "OFF" to "ON" Voltage rises
Selector lever: "N" to "D" Voltage rises
Vehicle speed sensor 4 Vehicle speed signal Road test the vehicle The speedometer and scan tool MB991958 display the same value.
(1) *: After the inspection is completed, disconnect the throttle position sensor connector, and then delete the diagnostic trouble code using scan tool MB991958. (Refer to DIAGNOSTIC TROUBLESHOOTING STRATEGY ).
About FixVault