MULTIPORT Fuel Injection (2.4L) - Eclipse - Symptom Procedures
- Symptom Procedures
- Inspection Procedure 1: Communication With Scan Tool Is Not Possible (Communication With All Systems Is Not Possible)
- Inspection Procedure 2: Scan Tool Communication With ECM < M/T > Or Pcm < A/T > Is Not Possible
- Inspection Procedure 3: The Malfunction Indicator Lamp (Service Engine Soon Or Check Engine Lamp) Does Not Illuminate Right After The Ignition Switch Is Turned To The "On" Position
- Inspection Procedure 4: The Malfunction Indicator Lamp (Service Engine Soon Or Check Engine Lamp) Remains Illuminated And Never Goes Out
- Inspection Procedure 5: Cranks, Won't Start
- Inspection Procedure 6: Starts Up And Dies
- Inspection Procedure 7: Hard Starting
- Inspection Procedure 8: Unstable Idle (Rough Idle, Hunting)
- Inspection Procedure 9: Idle Speed Is High (Improper Idle Speed)
- Inspection Procedure 10: Idle Speed Is Low (Improper Idle Speed)
- Inspection Procedure 11: When The Engine Is Cold, It Stalls At Idle (Die Out)
- Inspection Procedure 12: When The Engine Is Hot, It Stalls At Idle (Die Out)
- Inspection Procedure 13: The Engine Stalls When Accelerating (Pass Out)
- Inspection Procedure 14: The Engine Stalls When Decelerating
- Inspection Procedure 15: Hesitation, Sag Or Stumble
- Inspection Procedure 16: Acceleration Shock
- Inspection Procedure 17: Deceleration Shock
- Inspection Procedure 18: Poor Acceleration
- Inspection Procedure 19: Surge
- Inspection Procedure 20: Knocking
- Inspection Procedure 21: Dieseling (Run-On)
- Inspection Procedure 22: Too High Co And HC Concentration When Idling
- Inspection Procedure 23: Transient, Mass Emission Tailpipe Test Failure
- Inspection Procedure 24: Purge Flow Test Of The Evaporative Emission Canister Failure
- Inspection Procedure 25: Pressure Test Of The Evaporative System Failure
- Inspection Procedure 26: Generator Output Voltage Is Low (Approximately 12.3 Volts)
- Inspection Procedure 27: Fans (Radiator Fan, A/C Condenser Fan) Are Inoperative
- Inspection Procedure 28: Power Supply System And Ignition Switch-IG System
- Inspection Procedure 29: Fuel Pump System
- Inspection Procedure 30: Ignition Switch-St System < M/T >
- Inspection Procedure 31: Ignition Switch-St System And Transmission Range Switch System < A/T >
- Inspection Procedure 32: Ignition Circuit System
- Inspection Procedure 33: A/C System