FixVault

Data List Reference Table

CAUTION:
  • When shifting the selector lever to "D" range, the brakes should be applied so that the vehicle does not move forward.
  • Driving tests always need two persons: one driver and one observer.
NOTE: *:Disconnect the throttle position sensor connector, and then delete the diagnostic trouble code that was recorded during the inspection with the use of scan tool MB991958 after the inspection has been completed.
M.U.T.-III SCAN TOOL INSPECTION

M.U.T.-III SCAN TOOL DISPLAY ITEM NO. INSPECTION ITEM INSPECTION REQUIREMENT NORMAL CONDITION
APS (MAIN) 12 Accelerator pedal position sensor (main) Ignition switch: "ON" Accelerator pedal: Released 735 - 1,335 mV
Accelerator pedal: Gradually depressed Increases in response to the pedal depression stroke
Accelerator pedal: Fully depressed 4,000 mV or more
BREAK SW 06 Stoplight switch Brake pedal: Depressed ON
Brake pedal: Released OFF
CANCEL CODE < From January 2004 > 13 Cancel code Ignition switch: "ON" The cancel code, which set when the auto-cruise control system was cancelled at the last time, is set again.
CONT SW (CAN) 04 Auto-cruise control switch CANCEL "CANCEL" switch: ON ON
"CANCEL" switch: OFF OFF
CONT SW (RES) 03 Auto-cruise control switch ACC/RES "ACC/RES" switch: ON ON
"ACC/RES" switch: OFF OFF
CONT SW (SET) 02 Auto-cruise control switch COAST/SET "COAST/SET" switch: ON ON
"COAST/SET" switch: OFF OFF
CRUISE 09 Auto-cruise control operation Auto-cruise control: active ON
Auto-cruise control: Inactive OFF
IDLE SW 08 Accelerator pedal position switch Accelerator pedal: Depressed OFF
Accelerator pedal: Released ON
MAIN SW 01 Auto-cruise control switch CRUISE (MAIN) "CRUISE" (MAIN) switch: "ON" ON
"CRUISE" (MAIN) switch: "OFF" OFF
STOP LAMP SW 05 Stoplight switch Brake pedal: Depressed ON
Brake pedal: Released OFF
TPS (MAIN) 11 Throttle position sensor (main)*
  • Remove the intake air hose at the throttle body.
  • Disconnect the throttle position sensor connector, and then connect terminals 3, 4, 5 and 6 with the use of the special tool: MB991658 (Test harness).
  • Ignition switch: ON
Fully close the throttle valve with your finger 300 - 700 mV
Fully open the throttle valve with your finger 4,000 mV or more
No load 520 - 620 mV
A/C switch: "OFF" to "ON" Voltage rises
  • A/C switch: "OFF"
  • Selector lever: "N" to "D"
Vs 10 Vehicle speed signal Road test the vehicle The speedometer and scan tool MB991958 display the same value.