Auto-Cruise Control Switch Check
- Remove the auto-cruise control switch (Refer to AUTO-CRUISE CONTROL ).
- Measure the resistance between terminal 2 and terminal 3 when each of the "COAST/SET", "ACC/RES", "CANCEL" and "ON/OFF" switches is pressed. If values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.SWITCH POSITION CONDITION CHART
Switch position Specified condition "ON/OFF" switch "OFF" Open circuit "ON/OFF" switch "ON" Continuity (less than 2 ohms) "CANCEL" switch ON 202.5 - 208 Ω "COAST/SET" switch ON 610.5 - 624.5 Ω "ACC/RES" switch ON 1838 - 1877 Ω