Servo - Speed Control: Installation

Fig 1: Identifying Mounting Nuts, Servo Cable Sleeve, Servo And Cable Retaining Clip

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

1. Position servo (2) to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip (3).
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install two servo-to-mounting bracket nuts (1) and tighten to 7 N.m (60 in. lbs.).
   Fig 2: Identifying Speed Control Servo Components

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
5. Position servo assembly (6) to inner fender and install three screws (3). Tighten 3 screws to 4 N.m (30 in. lbs.).
6. Connect vacuum line (1) to servo.
7. Connect electrical connector (5) to servo.
8. Connect servo cable (2) to throttle body. (Refer to INSTALLATION ).
9. Install air filter housing assembly.
10. Connect negative battery cable to battery.
11. Before starting engine, operate accelerator pedal to check for any binding.