FixVault
Home › Mitsubishi › 2007 › Raider SE › Repair and Diagnosis › Engine Mechanical › Auxiliary Emission Control Systems › Engine And Emission Control › Switch - Speed Control › Installation

Switch - Speed Control: Installation

  1. Position switch to steering wheel.
  2. Install switch mounting screw and tighten to 1.7 N.m (15 in. lbs.).
  3. Plug electrical connector into switch.
  4. Install airbag module. Refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) - SERVICE INFORMATION article.
  5. Connect negative battery cable to battery.
About FixVault