Section 26 (Auto-Cruise Control - Lancer Evolution)
WARNING: This page is about a different variant/trim than selected.
- Auto-Cruise Control
- General Information
- Auto-Cruise Control System Diagnosis
- Introduction To Cruise Control System Diagnosis
- Diagnostic Troubleshooting Strategy
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- Symptom Chart
- Symptom Procedures
- Notes
- INSPECTION PROCEDURE 1: When the Brake Pedal is Depressed, Cruise Control System is not Cancelled
- INSPECTION PROCEDURE 2: When the Clutch Pedal is Depressed, Cruise Control System is not Cancelled < M/T >
- INSPECTION PROCEDURE 3: When the Shift Lever is Moved to "N" Position, Cruise Control System is not Cancelled < TC-SST >
- INSPECTION PROCEDURE 4: When the Cruise Control "CANCEL" Switch is Set to ON, Cruise Control System is not Cancelled
- INSPECTION PROCEDURE 5: Cruise Control Cannot be Set ("COAST/SET" or "ACC/RES" Switch Operation is not Available)
- INSPECTION PROCEDURE 6: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed
- INSPECTION PROCEDURE 7: When "ON/OFF" Switch is Turned ON, "CRUISE" Indicator Light Inside Combination Meter does not Illuminate (However, Cruise Control System is Normal)
- Data List Reference Table
- ECM Terminal Voltage Reference Chart For Cruise Control System Operation
- Special Tools
- On-Vehicle Service