Intake And Exhaust - Lancer Evolution

• General Information
• Service Specification
• Intake And Exhaust Diagnosis
  • Introduction
  • Troubleshooting Strategy
  • Symptom Chart
  • Symptom Procedures
    • Inspection Procedure 1: Exhaust Leakage
      • Diagnosis
    • Inspection Procedure 2: Abnormal Noise
      • Diagnosis
• Special Tools
• Troubleshooting
• On-Vehicle Service
  • Manifold Vacuum Check
  • Intake Charge Pressure Check
  • Turbocharger WASTEGATE Actuator Check
  • Intake Charge Pressure Control System Check
  • Turbocharger Waste Gate Solenoid Check
    • No.1 turbocharger wastegate solenoid or brown connector
      • A Operation check
      • B Check of coil resistance
    • NO.2 turbocharger wastegate solenoid or black connector
      • A Operation check
      • B Check of coil resistance
  • Turbocharger Bypass Valve Check
• Air Cleaner
  • Removal And Installation
    • Notes
    • Installation Service Point
      • >> A << Mass Airflow Sensor Installation
• Intake Manifold
  • Removal And Installation
    • Notes
    • Removal Service Point
      • << A >> No.2 Intake Air Temperature Sensor Removal
    • Installation Service Points
      • >> A << No.2 Intake Air Temperature Sensor Installation
      • >> B << O-Ring/Manifold Absolute Pressure Sensor Installation
  • Inspection
    • Intake Manifold Check
• Charge Air Cooler
  • Removal And Installation
• Exhaust Manifold And Turbocharger
  • Removal And Installation
    • Notes
    • Removal Service Points
      • << A >> Turbocharger Compressor Bracket Removal
      • << B >> Waste Gate Actuator Removal
      • << C >> Turbocharger Oil Feed Tube Removal
    • Installation Service Points
      • >> A << Turbocharger Installation
      • >> B << Turbocharger Oil Return Tube Gasket Installation
      • >> C << Turbocharger Bracket/Turbocharger Bracket And Turbocharger Assembly Coupling Bolt Installation
      • >> D << Exhaust Manifold And Turbocharger Assembly Coupling Bolt And Nut Installation
      • >> E << Turbocharger Exhaust Outlet Fitting Bracket Installation
      • >> F << Turbocharger Compressor Bracket Installation
  • Inspection
    • Exhaust Manifold Check
    • Turbocharger Assembly Check
• Exhaust Pipe And Main Muffler
  • Removal And Installation
    • Notes
    • Removal Service Points
      • << A >> Heated Oxygen Sensor Removal
      • << B >> Rivet/Front Floor Rear Panel Heat Protector/Front Floor Front Panel Heat Protector Removal
    • Installation Service Points
      • >> A << Rivet/Front Floor Front Panel Heat Protector/Front Floor Rear Panel Heat Protector/Rivet Installation
      • >> B << Heated Oxygen Sensor Installation