Module - Anti-Lock Brakes: Removal

NOTE: If the ABM needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new ABM. For axle type, refer to REAR AXLE - 8 1/4 or REAR AXLE - 9 1/4 . For tire revolutions per mile, refer to WHEEL AND TIRE . To program the ABM refer, to the Appropriate Diagnostic Service Information.

Fig 1: Identifying Module Mounting Screws, HCU And Pump Electrical Connector

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

1. Remove the HCU from the vehicle. Refer to REMOVAL .
2. Remove the module mounting screws (1).
3. Disconnect the pump electrical connector (3) from the HCU (2).
   Fig 2: Identifying Pump Electrical Connector And HCU

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
4. Remove the module (1) from the HCU (2).