FixVault
Home › Mitsubishi › 2009 › Raider 4D Pickup, RWD › Repair and Diagnosis › Engine Performance › Ignition System › Engine Electrical › Battery Tray › Installation

Battery Tray: Installation

Fig 1: Identifying Battery Tray
G05442432Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Clean and inspect the battery tray. See CLEANING .
    Fig 2: Identifying Battery Tray Bolts
    G04854933Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Position the battery tray into the vehicle.
  3. Install the six upper battery tray bolts hand tight.
    Fig 3: Identifying Six Upper Battery Tray Bolts Hand Tight
    G05442434Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Install the two front battery tray bolts hand tight.
    Fig 4: Identifying Upper Battery Tray Bolts
    G04854934Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Raise the vehicle on a hoist.
    NOTE: The middle bolt hole is to remain open for a front fender liner fastener (1).
  6. Install the two lower battery tray bolts (2). Tighten the bolts to 10 N.m (90 in. lbs.).
  7. Install the left front fender liner. Refer to LINER - FRONT FENDER .
    Fig 5: Identifying Battery Tray Bolts
    G04854933Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  8. Lower the vehicle.
  9. Tighten the upper battery tray bolts to 10 N.m (90 in. lbs.).
    Fig 6: Identifying Upper Battery Tray Bolts
    G05442437Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  10. Tighten the two front battery tray bolts to 8.5 N.m (75 in. lbs.).
    Fig 7: Identifying Engine Compartment Wire Harness Retaining Pushpins From Battery Tray
    G04854931Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  11. Install the engine compartment wire harness retaining pushpins (3) to the battery tray (2).
    Fig 8: Installing Engine Compartment Wire Harness To Battery Tray
    G05442439Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  12. Install the battery negative cable retaining pushpins (5) to the battery tray.
    Fig 9: Installing Antilock Brake System (ABS) Hydraulic Control Unit (HCU), Bolts And Battery Tray
    G04854929Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  13. Install the Antilock Brake System (ABS) Hydraulic Control Unit (HCU) (3) bolts (2) into the battery tray (1). Tighten the bolts to 18 N.m (160 in. lbs.).
    14. Fig 10: Identifying Integrated Power Module
    G04854927Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  14. Install the Integrated Power Module (IPM).
  15. Install the battery. See INSTALLATION .
  16. Verify proper vehicle operation.
About FixVault