Section 103 (Radio And Cd Player -- Lancer Evolution)
WARNING: This page is about a different variant/trim than selected.
- General Information
- Special Tools
- Diagnosis
- Introduction To Audio System Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC U0019: Bus off (CAN-B)
- DTC U0141: ETACS CAN timeout
- DTC U0151: SRS-ECU CAN timeout
- DTC U0154: OCM (occupant classification-ECU) CAN timeout
- DTC U0155: Meter CAN timeout
- DTC U0164: A/C CAN timeout
- DTC U0168: WCM CAN timeout
- DTC U0195: Satellite radio CAN timeout
- DTC U0197: Hands free module CAN timeout
- DTC U1415: Coding not completed/Data fail
- DTC B2420: Power integrated circuit
- DTC B2421: Radio tuner
- DTC B2423: 6CD player error
- DTC B2424: CD player error
- DTC B2450: Switch panel communication
- DTC B2451: Audio panel type error
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Power is not turned ON when the power switch is turned ON
- Inspection Procedure 2: No sound is heard.
- Inspection Procedure 3: No sound is heard from one of the speakers.
- Inspection Procedure 3: No sound is heard from one of the speakers.
- Inspection Procedure 4: The audio does not operate normally by operating the radio and CD player of the center panel unit
- Inspection Procedure 5: Audio illuminations does not work normally
- Inspection Procedure 6: The sound of external input are not played
- Inspection Procedure 7: Noise is Present while Moving (AM)
- Inspection Procedure 8: Noise is Present while Moving (FM)
- Inspection Procedure 9: Sound Mixed With Noise, Only at Night (AM)
- Inspection Procedure 10: Broadcasts can be Heard but Both AM and FM have a lot of Noise
- Inspection Procedure 11: There is More Noise on Either AM or FM
- Inspection Procedure 12: Noise is present while moving (FM)
- Inspection Procedure 13: Noise appears during vibration or shocks
- Inspection Procedure 14: Noise is detected with engine running
- Inspection Procedure 15: Constant noise
- Inspection Procedure 16: Noise Comes Out, but neither AM nor FM Sounds
- Inspection Procedure 17: Poor Reception
- Inspection Procedure 18: Distortion on AM or on Both AM and FM
- Inspection Procedure 19: Distortion on FM Only
- Inspection Procedure 20: Using the Auto Select Function, Too Few Automatic Stations are Selected
- Inspection Procedure 21: Preset Station are Erased
- Inspection Procedure 22: CD can not be inserted
- Inspection Procedure 23: No sound. (CD Only)
- Inspection Procedure 24: CD Sound Skips
- Inspection Procedure 25: Sound quality is poor
- Inspection Procedure 26: CD can not be Ejected
- On-Vehicle Service
- Service Data
- Removal And Installation
- Inspection