Section 109 (Multi-Media Communications System (MMCS) - Lancer Evolution)
WARNING: This page is about a different variant/trim than selected.
- MITSUBISHI Multi Communication System
- Special Tools
- Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Precautions On Servicing MMCS
- Service Mode
- Error Message
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B2226: AND error
- DTC B2240: Communication error with CAN Box
- DTC B2477: VIN not programmed
- DTC U0019: Bus off (CAN-B)
- DTC U0141: ETACS CAN timeout
- DTC U0151: SRS-ECU CAN timeout
- DTC U0154: OCM (occupant classification-ECU) CAN timeout
- DTC U0155: Meter CAN timeout
- DTC U0164: A/C CAN timeout
- DTC U0168: WCM/KOS CAN timeout
- DTC U0195: Satellite radio CAN timeout
- DTC U0197: Hands free module CAN timeout
- DTC U1415: Coding not completed/Data fail
- DTC No. U1417 Implausible coding data
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: No navigation screen is displayed
- Inspection Procedure 2: No sound is heard.
- Inspection Procedure 3: No sound is heard from one of the speakers.
- Inspection Procedure 4: The navigation system can be operated while the vehicle is driven
- Inspection Procedure 5: The screen is not normal in the navigation mode. (The own vehicle mark is dislocated.)
- Inspection Procedure 6: The AM/FM radio broadcasting cannot be received
- Inspection Procedure 7: GPS signal can not be received
- Inspection Procedure 8: CD/DVD cannot be played
- Inspection Procedure 9: Image of a DVD is played, but no sound is played
- Inspection Procedure 10: Sound of a DVD can be played, but no image is played
- Inspection Procedure 11: The picture and sound of external input are not played
- Inspection Procedure 12: Check the CAN box unit power supply circuit
- ETACS Function Customization Function
- Removal And Installation
- Inspection