FixVault
Home › Mitsubishi › 2010 › Lancer Evolution SE › Repair and Diagnosis › External Pages › Different variant/trim › Section 15 (Combination Meter -- Lancer) › On-Vehicle Service › Fuel Level Sensor Check › Fuel Level Sensor Float Height

Fuel Level Sensor Float Height

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel pump module (Refer to FUEL TANK <2.0 L engine, 2.4 L engine> or FUEL TANK <RALLIART>).
  2. When float is moved to contact the float arm on the stopper, ensure that stopper positions "F" (height A) and "E" (height B) are within the standard value.

    <FWD> Standard value: 

    STANDARD VALUE CHART

    Float position Float height {mm (in)}
    Stopper position "F" (height A) 181.5 (7.1)
    Stopper position "E" (height B) 26.7 (1.0)

    <AWD> Standard value: 

    STANDARD VALUE CHART

    Float position Float height {mm (in)}
    Main Sub
    Stopper position "F" (height A) 140.9 (5.5) 14.2 ± 3.0 (0.6 ± 0.1)
    Stopper position "E" (height B) 39.1 (1.5) 179.3 ± 3.0 (7.1 ± 0.1)
    Fig 1: Identifying Fuel Level Sensor Float Height
    G06669451Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
About FixVault