Section 99 (Door System - Lancer Evolution)
WARNING: This page is about a different variant/trim than selected.
- Specification(S)
- General Information
- Central Door Locking System Diagnosis
- Symptom Procedures
- INSPECTION PROCEDURE 1: Central Door Locking System does not work at All
- INSPECTION PROCEDURE 2: Central Door Locking System does not Operate even when Door Lock Switch of Power Window Main Switch Operated (Door Lock Switch of Front Power Window Sub Switch Operate Normally)
- INSPECTION PROCEDURE 3: Central Door Locking System does not Operate even when Door Lock Switch of Front Power Window Sub Switch Operated (Door Lock Switch of Power Window Main Switch Operate Normally)
- INSPECTION PROCEDURE 4: A Door cannot be Locked or Unlocked by The Central Door Locking System
- INSPECTION PROCEDURE 5: Selector "P" Position-linked Door Unlock Function does not Operate Normally.
- INSPECTION PROCEDURE 6: Ignition "LOCK (OFF)" Position-linked Door Unlock Function does not Operate.
- Power Window Diagnosis
- Diagnostic Trouble Code Procedures
- CODE NO. L0730: P/W (DR) SW pulse 1 disconnection
- CODE NO. L0732: P/W (DR) SW pulse 2 disconnection
- CODE NO. L0734: P/W (DR) Above window position
- CODE NO. L0736: P/W (DR) Sensor fail (ground)
- CODE NO. L0740: P/W (DR) 3 times jam - protection
- CODE NO. L0746: P/W (DR) Parameter read fail; CODE NO. L0750: P/W (DR) Position read fail
- Symptom Procedures
- INSPECTION PROCEDURE 1: Power Windows do not work at All
- INSPECTION PROCEDURE 2: Driver's Power Window does not work by means of the Power Window Main Switch
- INSPECTION PROCEDURE 3: Relevant Power Window(s) does not work by means of the Front and Rear Passenger's Power Window Sub Switches
- INSPECTION PROCEDURE 4: Front and/or Rear Passenger's Power Window(s) do not work by means of the Power Window Main Switch
- INSPECTION PROCEDURE 5: The Power Window Timer Function does not work Normally
- INSPECTION PROCEDURE 6: Power Window Anti-trap Function does not work Normally.
- INSPECTION PROCEDURE 7: The Window Glass Lowers Automatically while it is Rising
- Check At Ecu Terminal
- Door Diagnosis
- Symptom Procedures
- INSPECTION PROCEDURE 1: Water Leak Through Door Window Glass
- INSPECTION PROCEDURE 2: Door Window Glass Malfunction
- INSPECTION PROCEDURE 3: Water Leak Through Door Edge
- INSPECTION PROCEDURE 4: Water Leak from Door Center
- INSPECTION PROCEDURE 5: Door Hard to Open
- INSPECTION PROCEDURE 6: Door does not Open or Close Completely
- INSPECTION PROCEDURE 7: Uneven Gap Between Body
- INSPECTION PROCEDURE 8: Wind Noise Around Door
- How To Locate Wind Noise
- Special Tools
- On-Vehicle Service
- Door Fit Adjustment
- Door Window Glass Adjustment
- Power Window Check
- Glass Sliding Mechanism Check And Adjustment
- Power Window Safety Mechanism Check <Driver's Side Only>
- Power Window Timer Function Check
- Power Window Operating Current Check
- Learning Procedures Of The Power Window Fully Closed Position
- Central Door Locking System Check
- Check Of Key Lock Prevention Function
- Shift "P" Interlink Door Unlock Function Check <TC-SST>
- Ignition "Lock (Off)" Position-Linked Door Unlocking Function Check <M/T, TC-SST>
- Door Outside Handle Play Check
- Door Inside Handle Check
- Customization Function
- Door Assembly
- Door Glass And Regulator
- Door Handle And Latch
- Window Glass RUNCHANNEL And Door Opening Weatherstrip