Combination Meter Assembly
- General Description
- Combination Meters Diagnosis
- Troubleshooting Strategy
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1200: Defective odometer
- DTC B1201: Defective fuel gauge
- DTC U1073: Bus Off
- DTC U1100: Powertrain Control Module Time-out (Related to Engine); DTC U1101: Powertrain Control Module Time-out (Related to A/T)
- DTC U1102: TCL/ASC-ECU Time-out
- DTC U1109: ETACS-ECU Time-out
- DTC U1112: SRS-ECU Time-out
- DTC U1120: Failure Information on Powertrain Control Module (Related to Engine)
- DTC U1206: Flag invalid
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication with Scan Tool is Not Possible.
- INSPECTION PROCEDURE 2: Power Supply Circuit.; INSPECTION PROCEDURE 3: Odometer and Trip Meter are not Displayed.; INSPECTION PROCEDURE 4: No needle meters work.; INSPECTION PROCEDURE 5: When the Ignition Switch is Turned to the ON Position, the Indicator and Warning Lights do not Illuminate.
- INSPECTION PROCEDURE 6: Speedometer does not Work.; INSPECTION PROCEDURE 7: The Fuel Gauge Needle Moves Excessively.
- INSPECTION PROCEDURE 8: Tachometer does not Work.
- INSPECTION PROCEDURE 9: Fuel Gauge does not work (other meters work).
- INSPECTION PROCEDURE 10: Engine Coolant Temperature Gauge does not Work (other meters work).
- Data List Reference Table
- Actuator Test Reference Table
- Combination Meter Terminal Check
- Special Tools
- On-Vehicle Service
- Combination Meter Assembly