Steering Angle Check

CAUTION: After adjusting the steering angle, always perform calibration to make ABS/ASC-ECU learn the neutral position of the steering wheel sensor. (Refer to STEERING WHEEL SENSOR CALIBRATION ). < Vehicles with ASC >

Check that the wheel alignment is normal (Refer to FRONT WHEEL ALIGNMENT CHECK AND ADJUSTMENT ).

Place the front wheel on a turning radius gauge and measure the steering angle.

STEERING ANGLE STANDARD VALUE SPECIFICATIONS

Inner wheel	40°50' ± 1°30' (Difference between right and left wheels must be 2°00' or less)
Outer wheel (reference value)	33°50'

Fig 1: Placing Front Wheel On Turning Radius Gauge

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

If not within the standard value, adjust the tie-rods (right and left), and repeat Steps 1 and 2.
If the measured value exceeds the standard range by performing Step 3, replace the steering gear and linkage assembly (Refer to POWER STEERING GEAR BOX AND LINKAGE ).

Fig 2: Identifying Dimension Between Edge Of Bellows Assembly Groove And Jam Nut
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.