Combination Meter - Except Lancer Evolution
- General Information
- Service Specifications
- Special Tools
- Troubleshooting
- Standard Flow Of Diagnostic Troubleshooting
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1200: Malfunction of odometer
- DTC B1201: Abnormal fuel information < FWD >
- DTC B1201: Abnormal fuel information < AWD >
- DTC B1209: Test mode
- DTC B2203: VIN not programmed
- DTC B2463: Sticking of rheostat switch
- DTC B2464: The sticking of meter information switch
- DTC B2465: Ignition switch signal error
- DTC U0019: Bus off (CAN-B)
- DTC U0100: Engine control module CAN timeout
- DTC U0141: ETACS CAN timeout
- DTC U0151: SRS-ECU CAN timeout
- DTC U0154: Occupant classification-ECU CAN timeout
- DTC U0164: A/C/Heater control unit CAN timeout
- DTC U0168: KOS-ECU or WCM CAN timeout
- DTC U0184: Audio CAN timeout
- DTC U0245: Audio visual navigation unit CAN timeout
- DTC U1415: Coding not completed/Data fail
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Power supply circuit check
- Inspection Procedure 2: The speedometer does not work (the other meters work)
- Inspection Procedure 3: The tachometer does not work (the other meters work)
- Inspection Procedure 4: Tone alarm does not sound normally
- Notes
- Technical Description (Comment)
- Notes
- Seat belt reminder function
- Keyless operation key reminder tone alarm function (vehicles with KOS)
- Ignition key reminder tone alarm function (vehicles without KOS)
- Light reminder tone alarm function
- Door-ajar warning tone alarm function
- Freeze warning tone alarm
- Parking brake reminder tone alarm function
- Multi information display interrupt display tone alarm
- Meter information switch operation tone alarm
- Turn-signal light tone alarm function
- Paddle shift cancel tone alarm, Theft-alarm function, ETACS-ECU function customize tone alarm, A/C operation tone alarm, audio operation tone alarm
- Troubleshooting Hints
- Diagnosis
- Inspection Procedure 5: The combination meter light does not illuminate normally or the multi information display is not displayed normally
- Inspection Procedure 6: The multi information display screen cannot be changed with the operation of the meter information switch
- Service Data
- Actuator Test Table < Vehicles Without Color Liquid Crystal Display >
- Check Procedure For Each Multi Information Display Screen
- Check At Ecu Terminals
- On-Vehicle Service
- Speedometer Check
- Tachometer Check
- Fuel Level Sensor Check
- Meter Information Switch Check
- Service Reminder Function Set
- How To Set By Operating The Scan Tool MB991958
- How To Operate The Scan Tool MB991958
- 1. Reminder Reset (Indicator Off)
- 2. Next Schedule Reminder Cancel
- 3. Extra Reminder Setting
- 4. Extra Reminder Cancel
- 5. Periodic Reminder Schedule Set
- 6. Integrated Value Adjustment
- 7. Optional Int Schedule Setting
- How To Set By Special Operation Of Switch
- How To Cancel The Service Reminder Warning
- How To Set The Schedule
- How To Inactivate The Service Reminder Function
- Combination Meter