Scan Tool Or Voltmeter

If a problem is found in the Pulse Check, observe the table below.

SCAN TOOL OR VOLTMETER SYMPTOM CHART

SYMPTOM		INSPECTION PROCEDURE	REFERENCE
ETACS-ECU does not receive any signal from the key reminder switch.		N-1	INSPECTION PROCEDURE N-1: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE KEY REMINDER SWITCH
ETACS-ECU does not receive any signal from the hazard warning light switch.		N-2	INSPECTION PROCEDURE N-2: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE HAZARD WARNING LIGHT SWITCH
ETACS-ECU does not receive one of signals from the door lock actuators.		N-3	INSPECTION PROCEDURE N-3: ETACS-ECU DOES NOT RECEIVE ONE OF SIGNALS FROM THE DOOR LOCK ACTUATORS
ETACS-ECU does not receive one of signals from the door lock switch (incorporated in the power window main switch and power window sub switch.		N-4	INSPECTION PROCEDURE N-4: ETACS-ECU DOES NOT RECEIVE ONE OF SIGNALS FROM THE DOOR LOCK SWITCH (INCORPORATED IN THE POWER WINDOW MAIN SWITCH AND POWER WINDOW SUB SWITCH)
ETACS-ECU does not receive any signal from the liftgate latch switch. <ECLIPSE>		N-5	INSPECTION PROCEDURE N-5: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE LIFTGATE LATCH SWITCH. <ECLIPSE>
ETACS-ECU does not receive any signal from the trunk lid latch switch. <ECLIPSE SPYDER>		N-5	INSPECTION PROCEDURE N-5: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE TRUNK LID LATCH SWITCH. <ECLIPSE SPYDER>
ETACS-ECU does not receive any signal from the liftgate lock release handle. <ECLIPSE>		N-6	INSPECTION PROCEDURE N-6: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE LIFTGATE LOCK RELEASE HANDLE. <ECLIPSE>
Transmitter	ETACS-ECU does not receive any signal from the lock, unlock, liftgate <ECLIPSE>, trunk lid <ECLIPSE SPYDER> or panic switch.	N-7	INSPECTION PROCEDURE N-7: TRANSMITTER: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE LOCK, UNLOCK, LIFTGATE <ECLIPSE>, TRUNK LID <ECLIPSE SPYDER> OR PANIC SWITCH
ETACS-ECU does not receive any interior light loaded signal.		N-8	INSPECTION PROCEDURE N-8: ETACS-ECU DOES NOT RECEIVE ANY INTERIOR LIGHT LOADED SIGNAL
ETACS-ECU does not receive an auto-stop signal from the rear wiper motor.		N-9	INSPECTION PROCEDURE N-9: ETACS-ECU DOES NOT RECEIVE AN AUTO-STOP SIGNAL FROM THE REAR WIPER MOTOR
ETACS-ECU does not receive any signal from hood switch.		N-10	INSPECTION PROCEDURE N-10: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM HOOD SWITCH