FixVault
Home › Mitsubishi › 2012 › Lancer Evolution GSR › Repair and Diagnosis › External Pages › Different variant/trim › Section 41 (Front Axle - Lancer) › On-Vehicle Service › Hub Bolt Replacement

Hub Bolt Replacement

WARNING: This page is about a different variant/trim than selected.

Required Special Tools: 

  1. Remove the brake caliper assembly and brake disc, and retain the brake caliper assembly with a wire and the like to prevent from falling (Refer to FRONT AXLE HUB ASSEMBLY  ).
  2. Use special tool MB991618 to remove the hub bolts.
    Fig 1: Removing Hub Bolts Using Special Tool MB991618
    G05376081Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Install the plain washer to the new hub bolt, and install the bolt with a nut while holding the hub with special tool MB990767.
  4. Install the brake disc and the brake caliper assembly (Refer to FRONT AXLE HUB ASSEMBLY  ).
    Fig 2: Holding Hub Using Special Tool MB990767
    G05432066Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
About FixVault