DTC U0428: Communication Error In Steering Wheel Sensor: Notes

WARNING: This page is about a different variant/trim than selected.

CAUTION:

If diagnostic trouble code U0428 is set in ASC-ECU, always diagnose the CAN bus lines. If there is any fault in the CAN bus lines, refer to EXPLANATION ABOUT THE SCAN TOOL (M.U.T.-III) CAN BUS DIAGNOSTICS , an incorrect DTC may be set.
Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
When the steering wheel sensor is replaced, always perform calibration to make ASC-ECU learn the neutral point. (Refer to STEERING WHEEL SENSOR CALIBRATION .)
When the hydraulic unit (integrated with ASC-ECU) is replaced, after turning the ignition switch ON and OFF (vehicle information from ETACS-ECU is registered), always perform the calibration of steering wheel sensor, G and yaw rate sensor, brake fluid pressure sensor, cut valve, and inlet valve. (Refer to G AND YAW RATE SENSOR CALIBRATION , STEERING WHEEL SENSOR CALIBRATION , MASTER CYLINDER BRAKE FLUID PRESSURE SENSOR CALIBRATION , and CALIBRATION OF CUT VALVE AND INLET VALVE .)