Section 16 (Combination Meter - Lancer Evolution)
WARNING: This page is about a different variant/trim than selected.
- General Information
- Service Specifications
- Special Tools
- Troubleshooting
- Standard Flow Of Diagnostic Troubleshooting
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1200: Malfunction Of Odometer
- DTC B1201: Abnormal Fuel Information
- DTC B1208: Malfunction Of LCD Heater
- DTC B1209: Test Mode
- DTC B2203: VIN Not Programmed
- DTC B2463: The Sticking Of Rheostat Switch
- DTC B2464: The Sticking Of Meter Information Switch
- DTC B2465: Ignition Switch Signal Error
- DTC U0019: Bus Off (CAN-B)
- DTC U0100: Engine Control Module CAN Timeout
- DTC U0141: ETACS CAN Timeout
- DTC U0151: SRS-ECU CAN Timeout
- DTC U0154: Occupant Classification-ECU CAN Timeout
- DTC U0164: A/C-ECU Or Heater Control Unit CAN Timeout
- DTC U0168: KOS-ECU Or WCM CAN Timeout
- DTC U0184: Audio CAN Timeout
- DTC U0197: Hands Free Module CAN Timeout
- DTC U0245: Audio Visual Navigation Unit CAN Timeout
- DTC U1415: Coding Not Completed/Data Fail
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Power Supply Circuit Check
- Inspection Procedure 2: The Speedometer Does Not Work (The Other Meters Work)
- Inspection Procedure 3: The Tachometer Does Not Work (The Other Meters Work)
- Inspection Procedure 4: Tone Alarm Does Not Sound Normally
- Inspection Procedure 5: The Combination Meter Light Does Not Illuminate Normally Or The Multi Information Display Is Not Displayed Normally
- Inspection Procedure 6: The Multi Information Display Screen Cannot Be Changed With The Operation Of The Meter Information Meter Switch
- Service Data
- Actuator Test Table
- Check Procedure For Each Multi Information Display Screen
- Check At Ecu Terminals
- On-Vehicle Service
- Speedometer Check
- Tachometer Check
- Fuel Level Sensor Check
- Meter Information Switch Check
- Service Reminder Function Set
- Combination Meter