Section 47 (Door System - Lancer Evolution)
WARNING: This page is about a different variant/trim than selected.
- Specification(S)
- General Information
- Central Door Locking System Diagnosis
- Symptom Procedures - Central Door Locking System
- INSPECTION PROCEDURE 1: Central Door Locking System Does Not Work At All
- INSPECTION PROCEDURE 2: Central Door Locking System Does Not Operate Even When Door Lock Switch Of Power Window Main Switch Operated (Door Lock Switch Of Front Power Window Sub Switch Operate Normally)
- INSPECTION PROCEDURE 3: Central Door Locking System Does Not Operate Even When Door Lock Switch Of Front Power Window Sub Switch Operated (Door Lock Switch Of Power Window Main Switch Operate Normally)
- INSPECTION PROCEDURE 4: A Door Cannot Be Locked Or Unlocked By The Central Door Locking System
- INSPECTION PROCEDURE 5: Selector "P" Position-Linked Door Unlock Function Does Not Operate Normally
- INSPECTION PROCEDURE 6: Ignition "LOCK (OFF)" Position-Linked Door Unlock Function Does Not Operate
- Power Window Diagnosis
- Diagnostic Trouble Code Procedures - Power Window
- CODE NO. L0730: P/W (DR) SW Pulse 1 Disconnection
- CODE NO. L0732: P/W (DR) SW Pulse 2 Disconnection
- CODE NO. L0734: P/W (DR) Above Window Position
- CODE NO. L0736: P/W (DR) Sensor Fail (Ground)
- CODE NO. L0740: P/W (DR) 3 Times Jam - Protection
- CODE NO. L0746: P/W (DR) Parameter Read Fail; CODE NO. L0750: P/W (DR) Position Read Fail
- Symptom Procedures - Power Window
- INSPECTION PROCEDURE 1: Power Windows Do Not Work At All
- INSPECTION PROCEDURE 2: Driver's Power Window Does Not Work By Means Of The Power Window Main Switch
- INSPECTION PROCEDURE 3: Relevant Power Window(s) Does Not Work By Means Of The Front And Rear Passenger's Power Window Sub Switches
- INSPECTION PROCEDURE 4: Front And/Or Rear Passenger's Power Window(s) Do Not Work By Means Of The Power Window Main Switch
- INSPECTION PROCEDURE 5: The Power Window Timer Function Does Not Work Normally
- INSPECTION PROCEDURE 6: Power Window Anti-Trap Function Does Not Work Normally
- INSPECTION PROCEDURE 7: The Window Glass Lowers Automatically While It Is Rising
- Check At Ecu Terminal
- Door Diagnosis
- Symptom Procedures
- INSPECTION PROCEDURE 1: Water Leak Through Door Window Glass
- INSPECTION PROCEDURE 2: Door Window Glass Malfunction
- INSPECTION PROCEDURE 3: Water Leak Through Door Edge
- INSPECTION PROCEDURE 4: Water Leak From Door Center
- INSPECTION PROCEDURE 5: Door Hard To Open
- INSPECTION PROCEDURE 6: Door Does Not Open Or Close Completely
- INSPECTION PROCEDURE 7: Uneven Gap Between Body
- INSPECTION PROCEDURE 8: Wind Noise Around Door
- How To Locate Wind Noise
- Special Tools
- On-Vehicle Service
- Door Fit Adjustment
- Door Window Glass Adjustment
- Power Window Check
- Glass Sliding Mechanism Check And Adjustment
- Power Window Safety Mechanism Check <Driver's Side Only>
- Power Window Timer Function Check
- Power Window Operating Current Check
- Learning Procedures Of The Power Window Fully Closed Position
- Central Door Locking System Check
- Check Of Key Lock Prevention Function
- Shift "P" Interlink Door Unlock Function Check <TC-SST>
- Ignition "Lock (Off)" Position-Linked Door Unlocking Function Check <M/T, TC-SST>
- Door Outside Handle Play Check
- Door Inside Handle Check
- Customization Function
- Door Assembly
- Door Glass And Regulator
- Door Handle And Latch
- Window Glass RUNCHANNEL And Door Opening Weatherstrip